The Most Important Considerations in the Design of Sliding Bearing Structures

---

/*250*250 was created on 2017/12/25*/ var cpro_id = 'u3171089';

When designing sliding bearing structures, there are several critical factors that must be carefully considered to ensure optimal performance and longevity. Here are the key points to keep in mind: 1. **Oil Grooves and Oil Pads**: Proper placement of oil grooves and oil pads is essential for effective lubrication. Avoid creating sharp edges or abrupt changes that can disrupt the oil film. 2. **Avoid Sharp Edges**: Sharp corners or edges should be minimized as they can cause oil film breakage, leading to increased friction and wear. 3. **Keep Oil Holes Unobstructed**: Ensure that oil holes remain open and unblocked to allow proper oil flow into the bearing area. 4. **Avoid Full Ring Oil Grooves**: Do not install a full ring oil groove in the middle of the bearing, as this can create dead zones where oil cannot circulate effectively. 5. **Smooth Oil Film Entry**: The design should facilitate a smooth entry of the oil film to reduce resistance and improve performance. 6. **Oil Inlet from Non-Load Area**: Oil should be introduced from areas that are not under direct load to prevent contamination and ensure even distribution. 7. **Reliable Oil Supply**: If an oil ring is used, it must be designed to carry and distribute oil efficiently and reliably. 8. **Avoid Dead Zones**: Make sure no part of the bearing becomes an oil-inactive area, which could lead to overheating and failure. By following these guidelines, engineers can significantly enhance the efficiency, reliability, and lifespan of sliding bearings in various mechanical systems.

---

Recommended for friends: Comments | Close Window

Bearing Related Knowledge

Experts in bearing technology analyze the causes of linear bearing failures, discuss the quality requirements for bearing steel, and examine factors that affect bearing life. They also cover proper maintenance and protection methods for car wheel bearings.

This article is linked to http:// Please cite the China Bearing Network: http://

Previous: Details of Bearing Damage Next: Detailed Discussion on the Function and Characteristics of "Spindle Bearing Oil"

Glass Door Floor Springs

The Floor Springs with Speed Adjustment Valves with 130-0 degree and 130-20 degree double closing speed adjustment valves is made in 304 Stainless Steel to ensure durability. Latching and closing speeds can be easily adjusted to ensure safety. The Speed Adjust Floor Springs are suitable for maximum 1500 wide door leaf and the maximum bearing weight is 130kgs. The opening maximum of the door leaf is 105 Degree, can be located at 90 degree or 105 degree.

Floor Spring Door,Glass Door Floor Spring Price,Aluminium Door Floor Spring,Floor Spring Door Fitting

Leader Hardware Manufacturer Limited , https://www.leaderhardwarecn.com